Surface-directed spinodal decomposition in the pseudobinary alloy (HfO_2)_x(SiO_2)_{1-x}

Hf silicate films (HfO_2)_{0.25}(SiO_2)_{0.75} with thicknesses in the range 4-20 nm were grown on silicon substrate by atomic layer deposition at 350 deg.C.The Hf distributions in as-grown and 800 deg.C annealed films were investigated by high resolution transmission electron microscopy (HRTEM), angle-resolved x-ray photoelectron spectroscopy (ARXPS) and medium energy ion scattering (MEIS). HRTEM images show a layered structure in films thinner than 8 nm. The ARXPS data also reveal a non-uniform distribution of Hf throughout the film depth. Diffusion of SiO_2 to the film surface after a longer time anneal was observed by MEIS. All these observations provide evidence for surface-directed spinodal decomposition in the pseudobinary (HfO_2)_x(SiO_2)_{1-x} alloy system.Comment: 1o figures, one tabl

Inconsistency in 9 mm bullets : correlation of jacket thickness to post-impact geometry measured with non-destructive X-ray computed tomography

Fundamental to any ballistic armour standard is the reference projectile to be defeated. Typically, for certification purposes, a consistent and symmetrical bullet geometry is assumed, however variations in bullet jacket dimensions can have far reaching consequences. Traditionally, characteristics and internal dimensions have been analysed by physically sectioning bullets – an approach which is of restricted scope and which precludes subsequent ballistic assessment. The use of a non-destructive X-ray computed tomography (CT) method has been demonstrated and validated Kumar et al., 2011); the authors now apply this technique to correlate bullet impact response with jacket thickness variations. A set of 20 bullets (9 mm DM11) were selected for comparison and an image-based analysis method was employed to map jacket thickness and determine the centre of gravity of each specimen. Both intra- and inter-bullet variations were investigated, with thickness variations of the order of 200 um commonly found along the length of all bullets and angular variations of up to 50 um in some. The bullets were subsequently impacted against a rigid flat plate under controlled conditions (observed on a high-speed video camera) and the resulting deformed projectiles were re-analysed. The results of the experiments demonstrate a marked difference in ballistic performance between bullets from different manufacturers and an asymmetric thinning of the jacket is observed in regions of pre-impact weakness. The conclusions are relevant for future soft armour standards and provide important quantitative data for numerical model correlation and development. The implications of the findings of the work on the reliability and repeatability of the industry standard V50 ballistic test are also discussed